All ProgramsANSYSANSYS Analysis ToolsCAE

Changing The Element Size In ANSYS® Meshing(Iluustrated Expression)

You know that the element size factor is very important in ANSYS® meshing. Usually(not every time) when you have a smaller mesh size, you will have a much finer mesh structure also which means high-quality finite element analysis(FEA) with ANSYS®. In this article, we will show you how to change the Element Size of mesh structure in ANSYS® Mechanical.

How To Change Element Size Of Mesh Structure In ANSYS®?

Click on the ‘Mesh’ tab then change the Element Size.

You can enter an element size value as shown by the red arrow.

Click on ‘Generate Mesh’.

After entering an Element Size value as shown in the red box below, then click on Generate Mesh as shown by the red arrow above in ANSYS® Mechanical.

The changed Element Size value of ANSYS® Meshing.

So we obtained a 2mm element sized mesh structure as above in ANSYS® Mechanical.

Conclusion

As you understand that the changing element size in ANSYS® Mechanical Meshing is very basic.

Do not forget to leave your comments and questions below about the changing element size in ANSYS® Meshing.

NOTE: All the screenshots and images are used in education and informative purposes. Images used courtesy of ANSYS, Inc.

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button