Creating Corners From Sketch Entities With ‘Make Corner’ Command In Siemens NX

From line segments or other sketch entities, you can create corner structures in Siemens NX with ‘Make Corner’ command in Siemens NX. It is very useful thing to obtain corner sketch structures. In here, we explain how to create corner structures with ‘Make Corner’ command in Siemens NX with a very basic example below.

How To Use ‘Make Corner’ Command In Siemens NX?

Click on ‘Make Corner’ command in Siemens NX.

To create corner structures from sketch entities in Siemens NX, you must be inside an active sketch like above. Or if you want to create a corner structure from sketch entities, you need to inside the skecth of that sketch entities.

After entering into the ‘Make Corner’ command in Siemens NX, click to select line segments or proper sketch entities that constitutes cornerlike structures when they are extended.

Download And Install Siemens NX 9!

After the selection of sketch entities, line segments will be extended to create a corner like above. The preview is shown by red colors.

You can use ‘Make Corner’ comamnd on different line segments.

You can use ‘Make Corner’ command in Siemens NX on different line segments.

YOU CAN LEARN SIEMENS NX IN MECHANICAL BASE; Click And Start To Learn Siemens NX!

The use of ‘Make Corner’ command in Siemens NX is very simple like above. Do not forget to leave your comments and questions about creating corners with ‘Make Corner’ command in Siemens NX.

Your precious feedbacks are very important for us.

Share This Post! Share Tweet Share

Write your comment on this topic.