All ProgramsCADSiemens NXSiemens NX Commands

Drilling Standard Simple Hole In Siemens NX(Illustrated Expression)

In this article we will show you how to obtain standard-sized simple hole in parts of Siemens NX. You know that the standard holes are generaly used in machine parts and also simple holes are generally used for bolt assemblies in mechanical systems. Siemens NX has a special tool to obtain these standard size holes. We start with the how to drill standard simple holes to parts by using Hole command in Siemens NX.


How To Drill Standard Simple Hole In Siemens NX?

Click on the Hole command.

To drill standard-size simple hole to parts in Siemens NX, you need to click on the Hole command as shown by red arrow above.

Select the hole locations to drill standard simple holes.

You need to specify hole locations on Siemens NX part by clicking on Points dialog as shown by red arrow above.

Select hole locations by clicking on the part.

You need to select the whole hole locations that you want to drill simple geometry, you need to just click on the locations as shown b red arrows above. After you finished it, click on Finsh button as shown by red box above in Siemens NX.

Select simple form.

To drill simple holes on Siemens NX parts, select the Simple form from the Form And Dimensions tab as shown by red box above.

Adjust the geometric dimensions of simple hole geometry.

You need to specify your own simple hole dimensions in Siemens NX;

Diameter: It is diameter value of the simple hole to be drilled as shown by red arrow above.

Depth: This is the depth of the simple holes as shown by blue arrows.

Tip Angle: This is the tip cone’s angle of the drilled simple hole as shown by green arrow.

You can select Depth Limit.

You can select a Depth Limit method to drill simple holes as shown by green box above:

Value: Enter a depth value for simple hole.

Until Selected: It drills the hole up to selected feature.

Until Next: It drills the simple hole up to Next feature.

Through Body: It drill the whole body that simple hole geometry belongs.

Select one of them.

You can adjust the depth of the simple hole as shown in red box above;

Cylinder Bottom: 40mm depth will be adjusted according to the cylinder bottom.

Cone Tip: 40mm depth will be adjusted according to the cone tip.

After you done with the adjustments for your simple hole driling operation in Siemens NX, click OK or Apply to complete it.

The simple coned hole are drilled on the Siemens NX part with Hole command.

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button