All ProgramsCADCAMSiemens NXSiemens NX Commands

How To Create Points In Siemens NX(Illustrated Expression)

In some cases, there could be requirement about the specifying a point in a CAD project to use it later in some purpose in Siemens NX. In this article we will show you how to create a point in Siemens NX by using Point command. You could create your points efficiently if you follow the steps that we introduced to you. Siemens NX provides lots of tools to create a desired geometry features in general, also you will understand that this fact is also true for this topic also.

Our website includes lots of useful informations about various CAD programs, so visit the main page to see them…


How A Point Is Created In Siemens NX?

Click on the Point command in Siemens NX.

To create a point in Siemens NX, you need to click on the Point command as shown by blue arrow.

Select a point creation method in Siemens NX.

In the Point command interface in Siemens NXİ there are lots of point creation methods as above.

Inferred Point: You could create your point by selecting a point in drawing scheme in Siemens NX.

Cursor Location: You could click on drawing scheme to obtain points in Siemens NX.

Existing Point: You could create points om existing points in Siemens NX.

End Point: Simply selecting of en points of sketches in Siemens NX.

Control Point: You could place your point to a control point of a Spline in Siemens NX.

Intersection Point: You can select a intersection points of skethes to place your point in Siemens NX.

Arc/Ellipse/Sphere Center: You can place your point to centers of an arc, ellipse are a sphere in Siemens NX.

Angle on Arc/Ellipse: You could place your point on arc or ellipse by entering a angle value to place your point o arc or ellipse at an angle in Siemens NX.

Quadrant Points: You can place you point to quadrants of an arc.

Point On Curve: Edge: You could place your point on an edge or face by clicking in Siemens NX.

Point On Face: You could place your point on a selected face or plane.

Between Two Points: You place your point by selecting two of points to place your point between them by entering a value.

Spline Pole: You could place your points on selected Spline’s pole in Siemens NX.

Spline Defining Point: You can olace your point on selected Spline defining points.

Select a point location.

For example we selected an edge of the geometry to place out point as shown by blue arrow. Also you can enter your X, Y and Z coordinates according to selected reference to place your point as in the blue box in Siemens NX. You could finish your point creation in Siemens NX by clicking on OK or Apply buttons as shown by green box.

The point is created in Siemens NX with Point command.

Here that out point is created as shown by green arrow above.

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button