All ProgramsANSYSANSYS Analysis ToolsANSYS WorkbenchCAE

Large Deflection Option In ANSYS Structural Analyses

Large deflection is one of the most important in analysis settings in ANSYS® Mechanical static structural and transient structural analyses. If you are expecting large deflections from your analyses, you need to turn on this option in ANSYS® Mechanical.

By default, large deflection is ‘Off’ mode in ANSYS® Structural analyses. If you turn the large deflection option ‘On’, you will face more solution time and more requirements of the computational source. So, a good estimation and evaluation of the structural system before building the ANSYS® analyses is very important.

ANSYS Workbench for Mechanical Engineering: A Step by step to learn ANSYS Workbench

If you are interested to learn the ANSYS® at an engineering level, click on the given link or the ‘Shop Now’ button to check the recommended book by Mechanical Base, from Amazon!

You need to assess the situation that if you are expecting any large deflections from your models.

How To Turn On And Off Large Deflections Option In ANSYS® Mechanical?

Turn on or off large deflections in ANSYS® Mechanical.

To turn on or off the large deflections in ANSYS® Mechanical, just click on ‘Analysis Settings’ just below the analysis, as shown by the red arrow.

YOU CAN LEARN ANSYS® IN MECHANICAL BASE; Click And Start To Learn ANSYS®!

Beneath the ‘Solver Controls’, you can find out the ‘Large Deflections’ option. You can turn on or off the large deflections by using the drop-down menu as shown in the red box above.

Conclusions

Do not forget to leave your comments and questions below about the large deflections options in ANSYS® Mechanical below.

Do not forget to leave your comments and questions below about the installation of ANSYS® Mechanical.

NOTE: All the screenshots and images are used for educational and informative purposes. Images used courtesy of ANSYS, Inc.

Your precious feedbacks are very important for us.

Related Articles

One Comment

  1. can you please tell me how to apply 2 voltages with phase difference between them to a single structure

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button