All ProgramsANSYSANSYS Analysis ToolsCAE

Minimum And Maximum Probes In ANSYS® Mechanical

Minimum and maximum probes are very useful to show the minimum and maximum deformation or other physical values in ANSYS® Mechanical analyses. Here, we will show you how to add maximum and minimum probes in ANSYS® Mechanical with a very basic example below.

How To Add Maximum And Minimum Probes In ANSYS® Mechanical?

Add maximum and minimum deformation probes.

You can add minimum, maximum, and user-defined probes from the section that is shown in the red box above in ANSYS® Mechanical. From right to left, you can directly add a maximum deformation probe, minimum deformation probe, and user-defined probe.

Adding probes in ANSYS® Mechanical.

At the above deformation analysis example in ANSYS® Mechanical, we added maximum and minimum probes by activating them as shown by the red and green arrows above. Also, we added deformation probes by activating the last one as shown by magenta arrows. Just click on part to see the deformation at that point.

You can deactivate them to get rid of these probes.

Download And Install ANSYS® R17!

Conclusion

As you see above adding probes is very simple in ANSYS® Mechanical.

YOU CAN LEARN ANSYS® IN MECHANICAL BASE; Click And Start To Learn ANSYS®!

Do not forget to leave your comments and questions about adding maximum, minimum, and user defined probes in ANSYS® Mechanical below.

Your precious feedbacks are very important for us.

NOTE: All the screenshots and images are used for educational and informative purposes. Images used courtesy of ANSYS, Inc.

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button