Creating Corners From Sketch Entities With ‘Make Corner’ Command In Siemens NX
Moving curves and sketches in Siemens NX is a very easy process with ‘Move Curve’ command. You can move your sketch entities according to selected reference and reference points, which makes moving sketch objects is very effective. In here, we explain how to move curves and sketches in Siemens NX effectively with ‘Move Curve’ command, with a very basic example below.
To use ‘Move Curve’ command in Siemens NX sketching, you need to be inside an active sketch, or if you want to move a set of curves of sketches, you need to open their sketch like above.
Click on ‘Move Curve’ command as shown by red arrow above then select the curve set or skecthes that you want to move as shown by red box above. Then select a distance direction as shown by green arrow that selected curves will be moved with referenced on it. And select a pivot point for it as shown by blue arrow.
YOU CAN LEARN SIEMENS NX IN MECHANICAL BASE; Click And Start To Learn Siemens NX!
As you see, you can enter a distance and angle value as shown in blue box above. Or you can move your sketch set with your mouse, by dragging them.
As you see that above curve is turned and moved with entered distance and angle values, according to the reference distance curve with ‘Move Curve’ command.
The use of ‘Move Curve’ command is very simple like above in Siemens NX sketching. Do not forget to leave your comments and questions about moving curves with ‘Move Curve’ command in Siemens NX.
Your precious feedbacks are very important for us.