Resizing Lots Of Sketch Entities Same Time In Siemens NX

If you have lots of sketch entities that are needed to be resized into same dimension, or if you have lots of sketch entities in various dimensions that re needed to be same dimension, resizing them one by one can be very tough and time consuming. In this case, you can use ‘Resize Curve’ command in Siemens NX sketching. In here, we will show you how to use ‘Resize Curves’ command in Siemens NX with a very basic example below.

How To Use ‘Resize Curve’ Command In Siemens NX?

Specify the required curves for resizing in Siemens NX.

To use ‘Resize Curves’ command in Siemens NX, you need to be inside an active sketch. Or you need to edit the sketch entities that needed to be resized.

Click on ‘Resize Curve’ command in Siemens NX as shown by green arrow above. Then select all the multiple curves as shown by red arrowsa above after entering into the command. After that, enter a diameter value or dimension value as shown in red box above. This value will be the size of all the selected different sketch entities.

YOU CAN LEARN SIEMENS NX IN MECHANICAL BASE; Click And Start To Learn Siemens NX!

Click on ‘OK’ or ‘Apply’ button to complete the resizing in Siemens NX sketching.

Resized curves in Siemens NX sketching.

As you see above, all the sketch entities are resized into same sizes with ‘Resize Curves’ command in Siemens NX.

Download And Install Siemens NX 11!

Do not forget to leave your comments and questions about ‘Resize Curves’ command in Siemens NX below. Your precious feedbacks are very important for us.

Share This Post! Share Tweet Share

Write your comment on this topic.