All ProgramsAutoCADAutocad 2DAutoCAD CommandsCAD

Tan, Tan, Radius Circle Drawing In AutoCAD®(Illustrated Expression)

In this article on Mechanical Base, we will show you how to create circles that tangents to 2 objects in AutoCAD® drawing scheme by entering a Radius value to it. In Mechanical Base, we expressed the whole commands of AutoCAD® 2D, so you can learn the use of AutoCAD® 2D by reading articles from Mechanical Base about AutoCAD®’s drawing commands. This kind of circle drawing method is very useful to obtain circles that are tangent to other drawing features. It is very hard to obtain this kind of circle without the Tan, Tan, Radius circle command in AutoCAD®.

AutoCAD For Dummies

If you are interested to learn AutoCAD®2Dat an engineering level, click on the given link or the ‘Shop Now’ button to check the recommended book by Mechanical Base, from Amazon!

YOU CAN LEARN AutoCAD® IN MECHANICAL BASE; Click And Start To Learn AutoCAD®!

How To Use Tan, Tan, Radius Circle Command In AutoCAD®?

Tan, Tan, Radius command will be used.

Think about a situation occurred that in which you need to draw a circle that must be tangent to these lines as shown by a green line above in AutoCAD®. In these kinds of cases, you need to use the Tan, Tan, Radius circle command in AutoCAD®.

Click on the Tan, Tan, Radius circle command.

You need to click on the pop-up menu as shown by the green arrow above then click on the Tan, Tan, Radius circle command as shown by the green arrow above to create circles in AutoCAD®.

Click the first tangent line in Tan, Tan, Radius circle command in AutoCAD®.

After entering the Tan, Tan, Radius circle command, you need to specify the first tangent feature as shown by the green arrow above by clicking on it.

Click on the second tangent line in the Tan, Tan, Radius command.

After clicking on the first tangent, you need to select the second tangent line in the Tan, Tan, Radius circle command in AutoCAD® as shown by the green arrow above.

Enter a Radius value.

After specifying the second tangent line in the Tan, Tan, Radius command, enter a Radius value as shown in the green box above to create the desired circle geometry in AutoCAD®.

Created circle geometry by Tan, Tan, Radius command in AutoCAD®.

So we entered a Radius value of 1000 and we obtained a geometry like above.

Conclusion

Drawing these kinds of circle geometries is very easy as that with Tan, Tan, Radius command in AutoCAD®.

Do not forget to leave your comments and questions below about the Tan, Tan, Radius command in AutoCAD® below!

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button